Tools

U-Joint Installation Tool

This tool is used to align the Universal Joint with the output shaft of the transmissin when installing the engine or rear axle. The original wrench was produced by the Frank Mossberg Co. of Attleboro, MA. It is wrench #652 - Univ. Joint Tool for Fords. The original wrench had only the hooked end which is usefull in holding up the universal jount when working from the top. We added the open end which enables the wrench to also be used from under the car.

Band Clamp and Wrench

This tool is used when installing the bands. The U shaped clamp is placed over the ears on the bands to hold them compressed against the drums so that the transmission cover can be installed. The wrench is sized to fit the adjusting nuts on the brake and reverse bands.

Lang's Part Number	Description
3816-TCW	Band Clamp and Wrench

Valve Lifter Wrenches

New Item! These three thin wrenches are just what is needed to set the adjustable lifters. These wrenches are thin so that they fit into the tight confines of the adjustable part of the lifter. They will work on either the two or three wrench styles. One wrench is shaped to fit on the lifter. The other two are used for the adjustment bolt and if necessary the lock nut. One has a straight head and one is curved to allow greater flexability in getting the wrench on the bolt or nut.

Lang's Part Number	Description
TBD	Valve Lifter Wrenches